Tomato shibby webmon12/26/2023 Proto RefCnt Flags Type State I-Node Path Proto Recv-Q Send-Q Local Address Foreign Address StateĪctive UNIX domain sockets (only servers) Sample netstat output (see the 5th entry with the address ":::www": Active Internet connections (only servers) Tailing the Apache error_log also yields nothing.ĭoes anyone see anything obvious, or have some suggestions for things to try in order to get things working? Can I provide any additional info that would help? Running netstat, I can see the value in the "Recv-Q" column increment every time I attempt to access the served file via the browser, but its as if Apache won't or can't respond to the request. I have succeeded with installing Apache, and believe I have configured it correctly, but cannot get the default "It works!" page to load. For me works great, and shows as 1000M Full port speed.I'm working on setting up Apache on my router (on which I've installed Tomato, a custom linux-based firmware package). I checked this, and then attached to it my primary network cable that connects to the gateway. Two settings below it you will find “Bridge WAN port to primary LAN (br0)”. In fact it is shown in your picture of the wan settings where you have shown how to disable the wan. I learned that this router supports the use of the wan port under your “bridge-like” configuration example. Such routers allow the wan side to be connected to the larger network, regardless of bridge or nat configuration. And second, all other wifi routers that I have configured in this way supported a simple “bridge” mode to accomplish the task. For one I would prefer to have all five ports available. One thing that troubled me was the loss of the wan port. I made one small change at the very after all other modifications, and thought you might like to know about it. Exactly what I was looking for as your sample network architecture is very similar to mine. Great write-up on configuring a second router as an access point using Tomato by Shibby. Your access point router is ready to use. It can also be configured manually from the "Basic" - "Static DHCP/ARP/IPT" page. On a Tomato gateway, this can be done by following the "" link in the device list for that IP address. On your gateway, configure the the IP address you used ( 192.168.1.77) to be "reserved" or "static". You can use any port on this router to plug it into the main router and you can use any port on this router (including the WAN port) for other devices.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |